Finally. Make your palm to work _HOURS_ more.

[jpm0083]

Originally posted by holvoetn
Welcome to BrightHand, jpm0083

And thank YOU for the link !!

I must say, you surely entered the forum in the right supportive way
EDIT: Alas ... the link does not work (not your fault, Palmgear's ...)
See here this one works (I just downloaded it, I will now start playing with it ...)

thanks holvoetn. good luck with your next round of battery test.

Just so everyone know, Mobile-Stream is now on version 1.03 (same link).
There is a little nice documentation included as well.

[fnagle]

I don't know if it's my system of not, but version 1.03 on a T3 doesn't change the values displayed when adjusting the threshold.

The app has also "almost doubled" in size, which is probably due to additional "ads" which change at the top of the screen.

I've removed .03 and reverted back to .02

fnagle

[holvoetn]

Originally posted by fnagle
I don't know if it's my system of not, but version 1.03 on a T3 doesn't change the values displayed when adjusting the threshold.

The app has also "almost doubled" in size, which is probably due to additional "ads" which change at the top of the screen.

I've removed .03 and reverted back to .02

fnagle

???
What do you mean ?
The values on my display change as expected ...

[fnagle]

.03 numbers do not change.

deleted .02 installed .03, went back to .02



fnagle

[holvoetn]

Originally posted by fnagle
.03 numbers do not change.

deleted .02 installed .03, went back to .02



fnagle

I see ... but my screenshot was made with 1.03 ...

[fnagle]

Not to belabor the fact... but

I've deleted .02, soft reset, re-installed .03, soft reset - same results - cannot change the value. The scroll arrow indicates that it has received input (gets highlighted) but the numbers just don't change.

Deleted .03, soft reset, installed .02, soft reset, everything works well. Values change when the scroll arrows are pressed.

I'm only reporting what's been happening on "my" T3.

Should also mention that I've tried it both "in" the charging cradle and "out" of the cradle, thinking when it was charging there may be a problem. There was no difference with either "configuration".

fnagle

[DeanDC10]

I just deleted version 1.01 and installed version 1.03 and it works fine on my T3.

The numbers change as expected and change by "1" number when the arrow is tapped. I think it did every other number on the other version.

[leenman]

At the site where you download Full Power, it says:

"To set a low threshold, launch the program and tweak the "Shutdown Voltage" value. To quit the "long battery" mode just soft reset the device. "

What does "to quit the long battery mode" mean?

[Igor Porto]

Quiting long battery mode, is just like turning off the program.

To turn off, and recalibrate the battery VU, just soft reset.


Igor

[Pathdoc]

I am seeing the same behavior as fnagle. Set voltage back to 3.75. Exited program. DId soft reset. Deleted 1.02. Installed 1.03. When tapping arrows, numbers do not change. Did soft reset. Tried again with no luck.

Does someone have a version of 1.02 that they could send me? If so, drop me a PM.