Replacement screen for Zodiac 1/2 needed

Discussion in 'Tapwave' started by Tsukiko-chan, Jan 7, 2009.

Thread Status:
Not open for further replies.
  1. Konrad Pierce

    Konrad Pierce Village Idiot 2.0

    Messages:
    4,683
    Likes Received:
    6
    Trophy Points:
    213
    I don't know, personally, since - again - I'm not familiar with the zodiac. But I think the answer is no, wizkid.

    But the TX uses an entirely different (HVGA 480x320x16) resolution than the VGA screens discussed above. I believe the dimensions are different, too.

    Regardless, the digitizer resolution must match the display resolution to be of any real use. You can probably use any LCM you like that matches the resolution (even if larger than the PDA chassis), but you probably cannot use one with the incorrect resolution without adjusting the video/digitizer firmware or hardware.
     
Thread Status:
Not open for further replies.

Share This Page