Help WMP causes Qmenu to fail in and after use!

Discussion in 'iPAQ h3600-h3900 series' started by Unregistered, Jun 29, 2001.

Thread Status:
Not open for further replies.
  1. Unregistered

    Unregistered Guest

    Whenever I use WMP my Qmenu stops working and will not work even after i exit, i have to soft-reset to get it to work again. Anyone had this problem before or now a solution? Thank you for your help!

    P.S. Has anyone noticed how close-knit the pocket pc and palm communities are? (Please no flames, be mature enough to post a intelligent opinion) this goes for the communtiy at ticalc.org too where i work. it's very comforting
     
  2. MrWhipple

    MrWhipple Don't squeeze the XV6700!

    Messages:
    586
    Likes Received:
    0
    Trophy Points:
    66
    Do you have you QMenu set to perform a specific function in WMP? If so, it could be causing a conflict -- WMP's button assignments will override the system settings, even if WMP is not the active program.
     
Loading...
Thread Status:
Not open for further replies.

Share This Page